Automatic Technology GDO-9 Manuel d'installation télécharger pdf (Page 19)

CODING TRANSMITTERS

STEP 18

SETTING TRANSMITTERS CODES

Make sure to connect the battery to the transmitters.

The memory in the openers receiver can store up to 24

different remote control transmitters.

18.1 STORING THE TRANSMITTERS CODE

1. Press and hold the Door Code button (Fig. 34).

2. Press the button (one of four) on the transmitter you

would like to use to control the door for two seconds,

pause for two seconds. Press the same button again

on the transmitter for two seconds.

3. Release the Door Code button.

4. Press the transmitter button to test if it operates

the door.

18.2. SETTING THE TRANSMITTER

TO OPERATE THE COURTESY LIGHT

The transmitter can be programmed to operate the cour-

tesy light on the door opener.

1. Press and hold Light Code button (Fig. 34).

2. Press the button on the transmitter you would like to

use to switch on the light for two seconds, pause for

two seconds. Press the same button again on the

transmitter for two seconds.

Release all buttons to store the transmitter in memory.

4. Press the transmitter button to test if it switches on

the light.

18.3. SETTING THE TRANSMITTER TO OPERATE

PET (PEDESTRIAN) MODE

1. Press and hold Door Code button and the ( - )

button (Fig. 35).

2. Press the button on the transmitter you would like to

use to control pedestrian mode for two seconds,

pause for two seconds. Press the same button again

on the transmitter for two seconds.

Release all buttons to store the transmitter in memory.

4. Press the transmitter button to test if it operates the

pedestrian mode.

To change the default pet (pedestrian) door opening

position, refer step 24 on page 23.

18.4. SETTING THE TRANSMITTER TO OPERATE

VACATION MODE

1. Press and hold Light Code button and the Close

button (Fig. 36).

2. Press the button on the transmitter you would like to

use to control vacation mode for two seconds, pause

for two seconds. Press the same button again on

the transmitter for two seconds.

Release all buttons to store the transmitter in memory.

4. To test, press and hold the transmitter button set for

vacation mode for five seconds to set Vacation Mode.

To reset Vacation Mode press the same button for two

seconds. Please note that when vacation mode is

activated all stored transmitters will be locked out. This

mode can only be deactivated by a transmitter which

has been stored to activate this mode.

FIG. 34

Press and hold

Door Code Button

Select one of the four

buttons you wish to use

to control the door.

FIG. 35

Press and hold

Door Code Button

FIG. 36

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Automatic Technology GDO-9 Manuel d'installation Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Ouvreur de porte de garage Automatic Technology GDO-9