Automatic Technology GDO-9 Manuel d'installation Page 16

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 28
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 15
SETTING LIMITS
16
STEP 15
SETTING TRAVEL LIMITS POSITIONS
METHOD ONE: VIA THE CONTROL PANEL
IMPORTANT NOTE: The OPERATE button will not
function until the open and close limits positions are set.
Remove the controls cover to access the controls panel
as shown in fig 26
15.1 SETTING LIMITS POSITIONS
NOTE: The door and shuttle must be engaged into the
chain index and should be open approximately half way.
1. Press red Minus (-) button and hold it, the door will
start closing. Release the button once you have
reached your desired closed limit position. (Fig. 27)
2. Press the set button. This action will store into
memory the closed limit position.
3. Press the green Plus (+) button, the door will start
opening. Release the button once you have reached
your desired open limit position.
IMPORTANT WARNING: Please be aware that the
garage door will start closing automatically once step 4
is performed. The door will also automatically re-open
after fully closing with a small pause between the
cycles.
4. Press the Set button. This action will store into
memory the door limit position. The door will now
automatically close to its limit position then fully open
to calculate the safety obstruction forces (ISS).
Please be aware of the above warning.
The opener can now be operated via the OPERATE
Button.
15.2 RESETTING DOOR LIMIT POSITIONS
The door travel limit positions can be deleted for new
positions by the following steps below:
1. Press and hold the (-) button (Fig. 28) for six (6)
seconds until you hear three beeps and the red
Close Limit LED starts to flash. Release the button.
2. Follow STEPS 15.1 to set new travel limit
positions.
Go to STEP 17 and test the Safety Obstruction
Force.
FIG. 28
FIG. 26
FIG. 27
Vue de la page 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Commentaires sur ces manuels

Pas de commentaire