Automatic Technology GDO-9V1 SecuraLift Guide de dépannage télécharger pdf (Page 26)

GDO-9v2 SecuraLift

Owner Installation Instructions

ﬁ g

Final Set Up

Step 26 - Setting of Courtesy Light Time

The courtesy light time can only be adjusted with

the Universal Programmer (PG-3).

Step 27 - Setting the Pet Mode position

The default Pet Mode height can be changed as follows:

Make sure the door is closed, then press and

hold the OPEN button for six (6) seconds (Fig.

45), until you hear three beeps and the OPEN

and CLOSE LEDs ﬂash rapidly.

Press the OPEN or CLOSE button to move the

door to the desired pet mode open position.

Press the SET button to record the new position.

When activated, Pet Mode drives the door to the preset

position from either above or below. Pet Mode’s active

status is indicated by both the OPEN and CLOSE LIMIT

LEDs being illuminated. If a Pet Mode button is pressed

while the door is moving the door will stop. If a Pet

Mode button is pressed when the door is in the Pet

position, then the door will close.

Step 28 - Installing the Wall Mounted

Transmitter (Optional)

Remove the faceplate from the transmitter.

Afﬁ x the baseplate in a convenient wall location

that is out of reach of children and convenient

to the customer (Fig 46). Make sure the door is

visible from this location.

Replace the faceplate.

To code the transmitter, see Steps 10.1 through

10.4 on page 19.

Step 29 - Reset all Factory Defaults

Turn power to opener off.

Press and hold the SET Button (Fig 47).

Turn power on while holding the SET button.

Continue to hold until all LEDs are off.

This will not erase transmitter codes

stored in memory.

ﬁ g

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 35 36

Pas de commentaire

Automatic Technology GDO-9V1 SecuraLift Guide de dépannage Page 26