Automatic Technology GDO-9V1 SecuraLift Guide de dépannage télécharger pdf (Page 23)

Owner Installation Instructions GDO-9v2 SecuraLift

P.E. Beam & Auto-Close

Step 22 - Fitting the P.E. Beams (optional)

Affix the P.E. Beams (PE-2) in a strategic location

within the doorway. We recommend 150mm above

the floor level and as close as possible to the door

opening, inside the garage.

Connect the PE-2 (Order Code 90214) and the

P.E.Beam Interface Kit V2 (Order Code 01901) to

the Opener in accordance with (Fig.38).

Make sure to align the beams correctly. Follow the

manual supplied with the P.E. Beams.

WARNING: When using Auto Close Mode and P.E.

beams, the doorway must be clear of all obstructions

and persons at all times. The location of the beams

and the manner in which it is installed might not

give safety protection at all times. Check to make

sure that the height of the beam and type used

give maximum protection possible.

Step 23 - Setting Up Auto-close Mode

IMPORTANT NOTICE: It is compulsory to have P.E.

Beams installed when using Auto-close mode.

Auto-close mode is a function that automatically closes

the door a preset time after the P.E. Beams recognise

that a vehicle has left the garage.

The Auto-close timer only starts after the P.E. Beam's

path is broken the Auto-close timer has been set. If

the P.E. path is not broken the door will remain open

until the path is broken. If the opener incurs a physical

obstruction (i.e. not from the P.E. Beams) while closing

the door will re-open and not Auto-close until the P.E.

Beam's path is broken again.

Step 23.1 - Setting Auto-close Time

Hold down the AUTO CLOSE TIME button (Fig.39).

While holding in the AUTO CLOSE TIME button,

press the OPEN button - each press will add one

second to the Auto-close delay.

To decrease the delay time follow Step 15.1(a)

and press the CLOSE button - each press will

deduct one second from the Auto-close delay.

Press the OPERATE button or transmitter to open

the door. When the door is fully opened the

OPEN LIMIT LED will flash to indicate that Auto-

close mode is operational.

Break the P.E. Beam's path momentarily to

initialise Auto-close. When the door reaches the

fully opened position, the door will pause for the

set Auto-close time and then close.

fig

24V

12V

24V

12V

1 2

3 4 5

PWR

PE-

CABLE 1

CABLE 2

RECEIVER

TRANSMITTER

WIRE COLOUR: R-Red, B-Black, Y-Yellow

NOTE: Resistor R1 shall be 2.2kOhm, 1/4W

Model: PE-2 with harness

WARNING: The P.E.Beams will be active only after

the Opener has moved the door through a

completed open or close cycle.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Automatic Technology GDO-9V1 SecuraLift Guide de dépannage Page 23

Commentaires sur ces manuels

Produits connexes et manuels pour Ouvreur de porte de garage Automatic Technology GDO-9V1 SecuraLift